Interface Range Command Cisco. Basic cisco switch configuration snopopular For the interface range command, you are required to have one space before the dash or comma such as the commands below Instead of configuring each interface separately, this command allows you to define a range of interfaces and apply configurations to all of them at once
interface range command Batch configuration of multiple interfaces from www.n-study.com
If you have multiple interfaces that need to be configured with the same settings, you can use the interface range command to specify a range of interfaces to which the subsequent commands will be applied Instead of configuring each interface separately, this command allows you to define a range of interfaces and apply configurations to all of them at once
interface range command Batch configuration of multiple interfaces
If you have multiple interfaces that need to be configured with the same settings, you can use the interface range command to specify a range of interfaces to which the subsequent commands will be applied The Interface Range Specification feature is implemented with the range keyword, which is used with the interface command. For the interface range command, you are required to have one space before the dash or comma such as the commands below
Configuring LAG Settings on a Switch through the Command Line Interface. A useful feature is that you can configure a range of VLANs with a single command. The Interface Range Specification feature is implemented with the interface range command, which causes the device to enter interface range configuration mode
Configuring MACBased Authentication on a Switch through the Command. valid; the command interface range gigabitethernet 1-5 is not valid One such scenario is the introduction of "Interface Range" command in Network switches